Embossed Votive Holder Shade

Jan 7
22:00

2004

Michelle Gauthier

Michelle Gauthier

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Embossed Votive Holder ... the look of a Stained Glass Votive ... ... items can be found in the Scrap ... section of your local craft ... Clear

mediaimage

Embossed Votive Holder Shade
Create the look of a Stained Glass Votive Holder

Supplies Needed:
Most items can be found in the Scrap booking/Stamping section of your local craft store.
Straight-Sided Clear Glass Votive Holder
Vellum
Craft Markers of various colors
Hole Punch
Decorative String
Embossing Powder in your choice of color
Versamark Ink Pad
Embossing Heat Tool
Scissors
Tape Measure or Ruler

1. Measure the height and circumference of your Glass votive holder with a tape measure or ruler. Use these

measurements to cut out a piece of vellum. It is important to make sure that the vellum does not extend past the

top of the votive holder because this will increase the risk of a fire hazard.

2. After you have planned your design with your stamp(s),Embossed Votive Holder Shade Articles use the Versamark ink to stamp the design onto the

vellum. At this point the design will be clear.

3. Now sprinkle the embossing powder onto the stamped design. Turn the vellum upright and make sure all stray

powder has been shaken or tapped off. Also make sure that your entire design has been covered in powder. You

will be able to see this because the embossing powder will stick to the design that you stamped with the

Versamark inkpad.

4. Use your Embossing Heat Tool to heat the powder. But be careful because the heat tool can get VERY hot! You

will now have a beautiful raised design of the stamp you chose! Let cool for 1-2 minutes.

5. Now you can just color inside of the design on the opposite side of the vellum. Darker Colors look better for this

as they give a bolder appearance when the candle is lit. Allow to dry for approximately 5 minutes or the colors may

smear.

6. Finally, use your hole punch to make holes in the center of the shortest sides of the vellum. Run your string

through these holes and tie around your votive holder!

And, VOILE! A One-of-Kind Votive Shade that was fun and inexpensive to make! You can find more candle

decorating ideas at www.ExpressiveCandles.com

This Article was written by Michelle Gauthier of www.ExpressiveCandles.com. Michelle owns and runs Expressive

Candles. They offer hand poured scented candles and shaped tarts. Michelle also has written other candle

decorating articles, tips and candlescaping articles.

"Optional Image for Article: http://www.expressivecandles.com/emailnewletter/votivecovers.jpg"