Method of Repairing Holes in Wooden Doors

There might be a situation when the holes start getting appearing on the wooden doors. These holes on the wood make the door appear extra untidy and messy. In all such situations the best thing would be the repairing of the wooden holes. Now the main question arises that how can the holes be repaired? In this article we are highlighting few of the most eminent and prominent methods that would help the person in repairing the holes much perfectly. Firstly, the person should remove all the bolts and nuts from the door and lay it down on the sawhorses in such way that the holes of the door should be faced on the upward direction so that you can easily and much conveniently fix up wooden holes. Now take the edged weapon and remove all the dust and dirt inside the hole and then apply the solution of sand. Now after applying the sand just paste the sand paper with the help of the glue.

Make sure that the glue has been completely fixed up in the edges of the holes so that the whole hard work may not get wasted. Now take the wood putty and with the help of the knife just fill the empty hole with the wood putty. Now just continue filling the hole with the putty until the putty didn’t get fully filled with it. As the wood putty has been the wet solution so make sure that before staring any further steps just allow the wood putty to get dry. It will take maximum 6 hours for the solution to get properly dry out. Now once it gets dry fully just take the sand paper once again and fill the hole with the sand solution one more time. Now just remove the wood putty from the wooden door hole. If you feel that the hole has not been completely filled with the wood putty just repeats the whole process one more time and start with the sand solution once again.

Now your wooden door will be all set for repairing the wooden hole. This process would certainly appear to be much complicated while reading but you can even take the help from the expert as well. They would make you introduce with some of the additional effortless procedures that are much simple. On the other side when we look at the precautions then there are wide range of the precautions that has to be taken during the process. As the sand solution might appear to be allergic therefore the person must wear the gloves and dust mask before starting the method. On the whole we would say that this process method would eventually help the person in repairing the holes in much better and enhanced manner. So just follow these steps and make your door free from the holes. Just remember one thing that this process demands for huge attention and care while carrying out the process steps. So just follow it now.