Simple and very easy to follow water heater installation and maintenance tips for homeowners in San Francisco.
When it comes to the installation, care and maintenance of your water heater, San Francisco residents will need to know a few things about the installation and maintenance process. Although large and bulky, water heaters are relatively easy to install. However, you can use the services of a plumbing contractor San Francisco residents trust for proper water heater installation.
What follows are five simple tips about the proper installation and maintenance of your water heater. By following these tips, you can make the installation process smoother and get more out of your water heater over the long run so that it runs more efficiently.
Water Heaters Need to Be Replaced Every 10 to 12 Years
Unless the company from which the water heater was manufactured says otherwise, you will need to replace it around every decade. This is because the continued heat and moisture will wear on the heater until it starts to break down. While some water heaters will last longer, you should be thinking about getting a new one every 10 to 12 years.
Install the Same Type of Water Heater as the Previous One
Basically, you have the choice of using a gas or electric water heater, so the best one is what matches the previous water heater in your residence. Gas heaters are arguably more efficient, but if your residence is not connected to a gas line that may be a big extra expense to have the gas hooked up. However, you may reduce the size of the water heater if there are fewer people in your home which can save you money each month. Get the right size water heater for your residence that matches the number of people who live in the home for maximum efficiency.
Inspect your Water Heater Once a Month
An inspection consists of taking a few seconds to look over your water heater to check the connections and the floor for any signs of moisture. Quite often, major issues with your water heater start off as little leaks that may be fixed quickly and inexpensively rather than waiting for the damage to accumulate as the water builds up inside the walls of your residence.
Use the Vacation Mode
Many modern water heaters come with a Vacation setting which you can use when you leave the home for an extended period of time. By putting it into this setting, the water heater will go into a standby mode that will greatly reduce the electricity or gas it uses. Over a one or two week period, this can save you a considerable amount of money on your utility bill.
Drain It Twice Each Year
Over time, your water heater will accumulate sediments that will interfere with how efficiently it heats the water. By draining your water heater twice each year, you’ll remove a considerable amount of sediment build-up and improve the overall efficiency of your heater as well.
In order to ensure that your water heater installation goes smoothly, contact the trusted plumbing contractor San Francisco residents use for all of their plumbing needs.
