Fixing Garage Door Opener Problems And Reasons to Replace A Garage Door Opener

When their garage door opener reports some problems, there are a few ways they can fix it themselves. This article gives some easy garage door opener repair tips and also circumstances when they will need to change the opener. Owner’s manual is the first reference point for you to check for some guidelines regarding adjustments and repairs.

If the opener does not work with the remote or the all switch, probably you need to check the power source. Ensure whether the motor unit is plugged in and also check the circuit breaker, GFCI or fuse. If the garage door does not close all the way, then you will need to adjust the close limit switch. Otherwise, you can also check whether the door is binding when you raise or lower it manually. Also when the garage door reverses immediately after t hits the floor, you might need to check and adjust the close limit switch. If the garage door reverses before it hits the floor, then you can adjust the close force. If the door does not open completely, then you may need to move the limit switch a bit towards the motor unit.

When the motor does not stop even after the door opens, then you may need to move the limit switch away from the motor unit. If you are not able to open or close the garage door with remote control, then you can attempt any of the five adjustments including move close to the door to ensure you are within the range; ensure the antenna or the motor unit is hanging down; check whether the opener works well with the wall switch and replace the batteries in the remote or reprogram the remote.

Since garage doors feature quite simple mechanisms, most of them last for long without causing any problems. Though your garage door opener might work properly, you might consider replacing it since newer models add more safety, convenience and security. There are a few circumstances under which you will need to change your garage door opener. When you detect the following faults, then it is right time you go for a new opener to ensure the safety,

Originally, garage door openers were working with chain drives. These kinds of openers are prone to make a lot of noise. If you have a chain drive opener, then you may think of replacing it with a screw drive or belt drive garage door opener. Also, newer model chain drives are much quieter than older

Older kinds of garage door openers can be easily manipulated by thieves since the remote controls featured a fixed code and since some special devices can easily open them. The rolling code feature of the newer garage door openers changes the code every time when the door is used and therefore they cannot be duplicated or manipulated. 

Older garage door openers did not come with keypads that you can mount outside the garage. This handy feature enables you open the door by just entering a code into the keypad without having to use any keys. Check whether you can install a new keypad for your existing garage door opener. If you are not able to do this, then you can upgrade your door by installing a new opener. Once you do this, you can operate it by a torch or finger print detection mechanism without having to remember any code.

If you are using older models, you can think of changing them with new models featuring battery backup systems that enable you operate them without any interruption during power outage