There's a feeling of utter joy that comes over anyone that pushes a garage door opener. Garage door openers are relatively easy to fix and low maintenance! In this article we'll show you step by step, the ways in which to get that door back up and running in no time.
There's a feeling of utter joy that comes over anyone that pushes a garage door opener. Like magic,
the steel mammoth glides open and greet us with a promise of security and storage. But what happens when the opener breaks down? Luckily, garage door openers are relatively easy to fix and low maintenance!
In this article we'll show you step by step, the ways in which to get it back up and running in no time. An opener consists of an electric motor which lifts the mechanism at the push of a button. These devices can be wired into the electrical circuit, or used in combination with a battery powered remote: most systems have both. When pushed, the button sends an infrared signal to the control unit that, in turn, tells the motor to get to work.
Many various types of problems can occur:
1.The opener fails to respond.
2.The door may raise but fails to close.
3.The motor may run, but not open the garage.
4.The motor may run without any command at all!
5.The system may not open or shut completely
6.The motor may reverse when closing.
Due to the fact that these devices are little more than electronic controls and a motor, the majority of the servicing you can do starts with battery replacement, motor tests, and the lubrication and alignment of the mechanisms.
Identifying and Fixing the Issue:
1. In the case of the system being non-responsive, make certain the cord is properly plugged into a secured and operational electrical receptacle. Wait roughly 15 minutes and try again.
2. If the unit operates by remote by fails to work when used with the hard wired button, look for loose connections or damaged wires. If this is found, you may need to call an electrician.
3. If the opener runs but does not open the door, look for wear of the chain drive sprocket or worm gear, and if needed have the parts professionally look at.
4. If the unit operates by itself, check to see if the button on the remote has become stuck. If this is not the case, you may be looking at a faulty circuit board which may need to be replaced.
Chances are you just may find yourself in over your head. In such case, it's always recommended that you consult a professional technician as a way to help you avoid a more costly repair down the road. Though, hopefully with the above tips in hand you'll be able to successfully diagnose and treat your automatic door issues. Best of luck!
