How You Should Insulate The Basement Floor

The cool thing about having a basement is that you will have the capability to turn it into any kind of room that you want to have. Regardless of what you may use this room for it is imperative that you ensure it has an adequate amount of work done on it to prevent the cold and damp climate from getting in the way. These are essentially made underneath the ground and because of this they have a tendency to allow cold air to trickle through and now and then this can cause condensation. In other cases it will also allow water from outdoors to ooze through.

These troubles are so popular in basements because they are not constructed with the proper type of insulation. Either it is exceedingly thin or it is not all over the needed area. While the walls can have a certain quantity of this substance the floors frequently do not have anything at all.

Before setting down the ground work for the insulation you might need to check the whole space for leaks. You may need to seal any that you have found and lay down a heavy duty concrete sealer over the whole area. Ensure to clean the floor of dirt and debris before you do this.

Next thing that you will need to do is put up a raised floor. Purchase pressured treated lumber 2x4’s and put the flat side down against the floor. These are referred to as the sleepers. Make certain they are placed around the entire border and secure them to the floor with masonry screws every couple of feet.

After that, lay down more sleepers every 16” on the middle going from one wall to the next in the identical direction. You want it to seem like a neat grid. Ensure the that you toe nail the edges of the wood into the rim pieces that you have previously set up. Insert blocking every few feet between the sleepers in the opposite directions that they are going in.

Now you are all set to put down the insulation that you have chosen to go with. It is time and again simplest to utilize a type of basement insulation known as rigid foam. Place this in between the sleepers and make sure it is 1 - ½” deep. Cut off the surplus. Install a ¾" tongue and groove plywood above the sleepers and secure them utilizing galvanized 2” wood screws.