Setting up and modifying rc helicopter flight modes

If you happen to experience trouble with this important setting, depend on the docility with which the performance of your helicopter, you may need to remain patient. Look for manuals and get going. You can learn basics on how to set up and modify specific flying guidelines. In this sense, many rc helicopter fans can spend hours to get to leave in the finest way, given their finishing touches on the field and watching their behavior in flight!

Pitch curve

To know about the gas for each angle of the blades, you must first know about the angles that will determine the different phases and stages of flight. Starting from 0 ° you know that there is no need to lift and reach about + 5 ° or so to start the helicopter take off and remain still while in the air, no up or down. If you want to go smoothly, you must increase the angle of +5 ° starting at +6 °, +7 ° ù +8 º, depending on the speed with which you want to occur ascent to return back to the + 5 ° when you determine that no longer want to go more and still maintain the helicopter, but now at a greater height. From this position, if you fall, you will have to set the rc helicopter angle of the blades to your values of +5 °, such as +4 °, +3 °, +2 ° and so on.

Or you can produce the descent angles below 0 °, viz negative angles of the blades, as -1 ° -2 ° or -3 °, all depending on the speed with which you want to produce the decline. And once again, as soon as you have achieved the desired height, you have to go back to +5 °, to keep the helicopter still in that position. The flight still on the air without any movement is what is known as "hover".

In this sense, you can summarize the different angles that you need for the various phases of flight: Take off and hover: +5 º, rise up: + 8 º, descent Maximum: -3 °, That is, the different angles of the blades pass from -3 ° to +8 °, to an important point is to +5 °, not having much importance at the moment for any phase of flight, the 0 °, but for when you learn acrobatics. Master these three angles, since they are good so you know which positions are required to adjust your rc helicopter properly.