How to Use Engine Flush

Mar 3
17:28

2020

Katherine Makris

Katherine Makris

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

Apart from the pros and cons, if you are willing to use engine flush, then this will be a definitive guide to do it more precisely. Engine flush is something that can be done very easily prior to scheduling an oil change. It works with a short process only. It is a process of adding chemicals to your engine oil so that it can dissolve the sludge & gunk, which are accumulated for a long time of engine usage. Harmful deposits and sludge causes loss of power and performance. Engine flush enables your car to accumulate maximum efficiency as like the time you bought it. It helps to reduce heat as well as emissions. But you need to always refer to your factory service manual.

mediaimage

Apart from the pros and cons,How to Use Engine Flush Articles if you are willing to use engine flush, then this will be a definitive guide to do it more precisely. Engine flush is something that can be done very easily prior to scheduling an oil change. It works with a short process only. It is a process of adding chemicals to your engine oil so that it can dissolve the sludge & gunk, which are accumulated for a long time of engine usage. Harmful deposits and sludge causes loss of power and performance. Engine flush enables your car to accumulate maximum efficiency as like the time you bought it. It helps to reduce heat as well as emissions. But you need to always refer to your factory service manual.

Reading the User Manual

Consider reading the owner's manual of your vehicle and the manual of engine flush oil. Thus you will know the appropriate time to apply it and any specific requirements. It is always safe to look at the manual.

Measure the Flush Application Rate

The next important part is to measure the flush requirements. It is essential to put in a correct rate to flush the engine properly.Always remember that the application rate is 50ml per litre of oil. Which means 1 litre engine oil requires 50ml engine flush. For example, You need to use 250ml for 5 litres.

  • Check the engine oil capacity of your vehicle in the owner's manual.

Warm-up the Engine

Here most of the people do mistake that they do not warm up their engine. But it is essential to transform your car engine up to full operating temperature to clean up the junk. Because of sludge & gunk sticks with the engine surface when it is cold, and it can not mix with the flush oil. The full operating temperature will help the oil to flow better and move around the engine easier.

Add the Flush Product to the Engine

Now open the engine cap and fill it with the measured amount of flush oil. And close the engine cap.

  • Make sure that your engine is turned off.
  • Make sure you replace your cap.


Restart Vehicle in Neutral and Idle mode

Start the vehicle and make it in idle mode. Make your vehicle idle 10 minutes up to 15 minutes depending on the severity of engine sludge. The product will do his job and once you have touched the limit, then turn off your engine.

  • To mix the flush with oil properly, you need to accelerate the vehicle for 15 to 20 seconds.
  • Do not drive the car after filling flush as it can damage your engine parts.

Drain & Change the Oil

Allow your engine to cool down but not entirely. This has to be done when the vehicle is still hot so that the oil can flow smoothly. Now open your drain plug and drain the oil properly. After that change the oil filter and close the drain plug. Now it's time to refill your fuel.

  • It is essential to replace the oil filter every time you are changing oil