Only Use Reputable Oil Well Paraffin Treatment Providers
The most common problems found in wells are the deterioration of oil and gas products. If treated properly it can be an easy thing to correct. Making ...
The most common problems found in wells are the deterioration of oil and gas products. If treated properly it can be an easy thing to correct. Making use of an oil well paraffin treatment will increase production,
sometimes as much as 100 percent.When the oil is kept as a liquid it will not cause any problems, however if it solidifies it can be compared to the hardening of candle wax. Treatment needs to be started as soon as possible as it can cost the company millions. Some may even have to abandon wells altogether.Products when applied make a barrier between the wax crystals. This forces them to remain apart, very similar to the positive and negative of a battery. The edges will begin to distort, thus preventing them from fusing together again.Many companies will use their own formula when dealing with this clean-up. However, the same method is used. The well is pumped until everything is out. Then depending of the chemical they use, up to 5 gallons can be added to 220 gallons of crude oil as well as 20 g's of road fuel oil. This is all dumped down and an air compressor is connected. This pressure will be applied for about one to one and a half hours at a maximum pressure of 135psi, and then the well will be sealed off.It has been documented that suspended particulate matter such as corrosion products; silt and sand, will speed up precipitation. They act as a nucleus and make the smaller substances into larger particles. These tend to separate easier from the oil, but can still remain in a suspension and not deposited when oil is flowing.For the removal of paraffin the best solvents to use are xylene based. Using toluene is also a good product but because of the -40 C/F flash points it can be a hazard. The poorest ones to use are hot oil, diesel and some naphthas. Sometimes clean kerosene can be used but always test first.After the correct location has been found, the hole is drilled. Sections of steel pipe which are a little smaller than the diameter of the borehole are lowered. Concrete is usually added, so that it will provide structural integrity and make any future work a lot less dangerous to the operators.Sometimes it is necessary to go off shore, deep under the ocean floor. This is very dangerous but can also be very rewarding. Sometimes things can go wrong and can turn very nasty, even deadly for both the workers and the sounding area. A mobile offshore drilling unit is used to find the correct location.Special chemicals are used to ensure that production will not be threatened as the pipes begin to get blocked. A survey was done indicating that over 90% have been left prematurely because of this problem. For some smaller countries, whose lively hood depends on import and export, it is vital that oil well paraffin treatment get done regularly. As soon as the flow is weaker than normal, specialists are bought in before it becomes disastrous.