What should be noticed when choosing customized kitchen cabinets

Customized kitchen Cabinets carcase acceptance notice

1, Flatness. Before install the countertop, shake the cabinet carcase to check its solidity, and after the installation, use the horizontal ruler to measure the cabinets.2, Edge. For quality kitchen cabinets, its edge banding is delicate, smooth, feel good, straight line closure and with fine joint. Big brand manufacturer, edge banding machine one time finishing edge banding, decapitating, trimming, chamfering and polishing process, uniform coating, sealing pressure to stabilize sticking to ensure the most accurate size. While for workshop type small factory, artificial glue, sticking and pressing, edge, polishing, due to uneven pressure, the edge is not strong in many places, can also cause harmful gas volatilization plate into the air.3, Waterproof aluminum foil. The sink cabinet plate is affixed with a whole piece of waterproof aluminum foil, and three sides to flip up 1cm to prevent condensed water of the tank or pipe to erode the kitchen cabinets.

Customized kitchen cabinets door acceptance notice

1, Color. Check whether the door color and material are consistent with the order. A little difference in the color of the door and the color card is is normal, but do a finished whole cabinets door color does not allow a color difference.2, Positive and Negative side of the door. Confirm the positive and negative surfaces of the door panels are not deformed, scratched, and so on.3, Door seal. The door seal should be consistent with uniform width, crack width in 1-2mm.

Countertops acceptance notice

1,Flatness. Once the table is installed, it must be checked the level again with the leveling instrument.2, Joint. After installed, if you can clearly see seam gum waterline, or using a hand to feel the obvious wrong seam, seam certainly was not done well.3, Color difference. Same type color of man-made stone, due to the different date of production time there will be a certain degree of color difference phenomenon, consumers in the table should pay attention to the comparison.4. Groove. For the position of the sink and stove, need to groove, the edge of opening to be tactful, cannot have a saw tooth shape; four angle of the countertop should do a certain radian, not the right angle with simple, and should be particularly strengthened.5, Water retaining. In order to prevent the water from the surface of the table, the countertop near the wall will certainly form the water retaining. Need to note is that this must be a smooth curve, and can not be a right angle, otherwise it will be difficult to clean.6, Glue. The place where the water retaining and the wall is connected to the wall is connected with a white glass glue, and the surface of the countertop and the sink is connected with the transparent glass glue. Before spreading the glue, owners must check whether the glass glue have mouldproof function, and after spreading glue, must supervise workers to clean the excess glue in a timely manner.