If You Do Any Home Improvement You Need A Stud Finder Tool

If you do any home improvement yourself, you need to have certain tools, including a stud finder tool. If you are planning on hanging heavy artwork or you want to install a new chandelier from the ceiling, you need to make sure that these things are hung on a stud so they are going to be secure and not fall down. In order to find the studs, you need to have the right tool. Otherwise, you could end up banging on the walls and making marks or even holes in spots while you are trying to locate the studs.

Using a stud finder is really easy. You can get different models, which are all hand-held. Some will flash a light when a stud is detected, while others will emit a beeping noise. It may take a few minutes to figure out how to use this tool properly, but after that you will have no problems find any studs in your home. Here are some simple tips that make it easy to find studs using one of these tools:

• Make sure the wall is clear. If there are any paintings or photos hanging, remove them before you start trying to locate studs.
• Turn the stud finder tool on, hold it against the wall and press the button until the light flashes or you hear a beep. This will calibrate the tool. If you are doing this against a stud, it will not work, so you may have to end up doing it again to make sure that it is properly calibrated. Basically, this tells the device which parts of the wall are actually wall, and which parts have a higher density and are studs.
• Place the device flat against the wall, and start running it around the area where you are going to be hanging something. You should move it slowly, in a horizontal direction to get the best results. Make sure that you have the button pressed, or you will not get a flash or beep when you pass over a stud.
• When you hit a stud, the device will beep or flash at the outer edge, and again at the other edge. These are the places you need to mark with a pencil so you know where the studs are later on when you begin working. Once you have completed scanning the area, you can get to work hanging your artwork, photos, light fixtures and more.

The thing you need to remember about these tools is that they are all different, and they are not all used in the same manner. This is why it is important to read the directions before you set out to work. There are also some models that are more complicated than others. You can ask someone at your local hardware store which model they recommend. If you have never used a stud finder tool before, make sure that you get the simplest model that is going to be easy for you to use.