Perfect Carpet Repair Ideas: Snag Problem Solved

Jan 8
09:14

2013

Ma. Theresa Galan

Ma. Theresa Galan

  • Share this article on Facebook
  • Share this article on Twitter
  • Share this article on Linkedin

More often than not, pet toenails and furniture moving are the main causes of snagged carpeting. This also happens when a dog gets his nail caught or a child just can't help pulling on a loose thread

mediaimage
Before you know it your carpet is unraveling like an old wool sweater. Carpet snags are unsightly. There are several different methods to fix a run like this. Try to check how to do a proper patch.

If you have a shag type carpet,Perfect Carpet Repair Ideas: Snag Problem Solved Articles you can remove carpet snags by simply snipping away the fuzzy edges of the snags with a pair of sharp scissors. Running your hand over the trimmed area helps blend the cut fibers into the carpeting again. Removing snags in tightly woven berber carpet takes a bit more effort to keep the carpet looking like new.

Method to Consider:

Before you start you should gather some tools and materials.

   

- Slotted blade knife (keep a new sharp blade in it at all times, change it every few cuts) - Glue gun - Awl or knitting needle - Small glass of water - Blue painters tape - Scissors - Seam tape - A scrap of carpet from the original installation or from a closet.

1) Start by isolating the problem. Use the blue painters tape to hold the undamaged part of the carpet out of the way. What you should see is the backing of the damaged part of the carpet and nothing else. By doing this you will avoid getting glue on the nap of the carpet. If you do get glue on the nap it's going to feel hard to the touch. (and that's not a good thing)

2) Use your slotted blade knife to cut away the damaged thread.

3) Use your slotted blade knife to cut out the backing of the carpet. The cut should be close to the row of nap but not so close that you will cut into it. Be very careful not to cut the nap. You will now be looking at the carpet padding.

4) If you did accidentally cut some nap, use your glue gun sparingly to glue it back into place.

5) Use your scissors to cut the amount of carpet you will need to place in the patch. Again, cut it close to the row but be careful not to cut the nap. Also be sure the piece of carpet you are using for the patch is running the same direction as the rest of the carpet.

6) Cut a piece of seam tape about an inch or so longer than the patch. Center it under the cut carpet.

7) Check to be sure that your patch is cut exactly perfect. There's no going back after this step.

8) Use your glue gun to apply a moderate amount of hot glue to the first inch of the seam tape. Get the glue under the edges and across the field of the seam tape. Place the tip of the Berber patch where it belongs (in the glue) and push down hard enough to force the glue up into the backing. You should use enough glue so that it seals the edges all the way around without oozing up. Don't be shy with the hot glue

9) Dip the awl into the water and use the wet tip to adjust the patch, pushing gently where it needs a little help. The water will help prevent the glue from sticking to the awl.

10) Continue along until you have glued the entire piece in place. Take it slow and use the wet awl.

If you prefer not to cut longer pieces off to remove carpet snags, you can work snagged fibers back into surrounding fibers with a pair of knitting needles or a crochet hook, much like you work a snag out of a sweater. Once you have the fibers back into position, re glue them with carpet adhesive or a hot glue gun.

Keep your pet's toenails trimmed to help avoid future snags. Never give a snag a pull, hoping to break it off. You're more likely to create a long trench in your carpeting that you will have to painstakingly repair.

For more useful tips, check out our main page here:

Auckland carpet repairs