With the increasing use of Hard Drive Enclosures to reuse salvaged hard disks one of the common mistakes is forgetting to change the jumper settings on the hard disk before using it with the enclosure. Here are a few pointers on what to do and why hard drive enclosures are such a good idea.
Hard Drive Enclosures are getting increasingly popular, which, given their cost and ease of use is not surprising. Enclosures are a great way to re-use on old or salvaged hard disk drive from a computer and whilst these older hard drives are always as large as the current models (in terms of storage capacity) it’s a real shame not to use them
By way of example a salvaged 120GB hard disk drive will hold up to 30,000 songs, 150 hours of video, or 25,000 photos and the old work file of course! So even at the rate that people are saving files today that’s still a huge amount of information that the hard drive is capable of storing.
Hard drive enclosures will of course support new hard disks as well as any salvaged hard disks you happen to have lying around at home or work. If you do use an enclosure with a new hard disk then you could install a 1.5TB hard disk into the enclosure and create a very substantial back-up solution
For most people though the real benefit of an enclosure is that it allows the recovery of data from a hard disk taken out of an old PC and it then allows you to use that same hard disk to create a new back-up solution. By doing this you get real cost benefits combined with a sense of satisfaction that you are re-cycling what would otherwise be a scrapped piece of hardware.
If you are using an IDE or ATA Hard Disks with an enclosure then it’s important that you set the jumper settings on the disk to “master” and not cable select or slave. If the jumper setting is incorrectly set then the hard disk will not be recognised when connected to the PC. The default setting when removing a hard disk from a PC is not always master and whilst it seems logical that any disk installed in an external enclosure is set to “salve” but it does need to be set to “master”.
Changing the jumper settings is easy to do and only takes a few seconds. Typically the hard disk manufacturers will have put a label on the top of the hard disk illustrating how you set the jumpers.
Jumpers are just metal pins that have small black plastic sleeves that slot on them.
SATA hard disks have no jumper setting to worry about
What Do You Give An Executive That Has Everything
Normal 0 It’s that perennial challenge. You want to send out some gifts to your executive staff or high net worth clients but the gift has got to ooze quality and style without costing a fortune. Not only that but the gift has got to be appropriate and relevant and worthy of adding your brand to – no small challenge then!USB Christmas Gift Ideas
Normal 0 Although we’re only in October its time to start thinking about whether you are going to send out any Christmas gifts to your customers, clients and staff. Leave it much later and you may struggle to get exactly what you want and more importantly you might struggle to get your Christmas gifts printed with your logo and any message you might want on the gift.To Box or Not to Box that is the Question
Normal 0 There are two schools of thought on whether you should put your printed USB flash drives in a gift box or not with the pro-box lobby being keen to ensure that the USB drives not only look the part but have a real impact when handed out. There’s no escaping the fact that branded USB flash drives look better boxed up, they look more like a “proper gift” and the when handed out the they create more of an impact.